Lenze 9300 - Possible Axis Synchronisations; Cycle Times

Function library
7-269
L
EDSVS9332P-D21 EN 3.0
Function
• Possible axis synchronisations (chapter 7.5.79.1)
• Cycle times (chapter 7.5.79.2)
• Phase displacement (chapter 7.5.79.3)
• Synchronisation window for synchronisation via terminal (SYNC WINDOW) (chapter 7.5.79.4)
• Correction value of phase controller (SYNC CORRECT) (chapter 7.5.79.5)
• Fault indications (chapter 7.5.79.6)
• Configuration examples (chapter 7.5.79.7)
• Scaling (chapter 7.5.79.8)
7.5.79.1 Possible axis synchronisations
Operating mode
Code Value Function
C1120
0 FB without function.
Assigns the data at the inputs directly to the outputs.
1 CAN Sync active
Synchronises the controllers to the sync telegram of the system bus.
2 Terminal Sync active
Synchronises the controllers to the sync signal of terminal X5/E5.
Synchronisation time
After mains connection and initialisation time of the controller, the FB SYNC1 also requires a
synchronisation time.
The synchronisation time depends on
• the baud rate of the system bus (CAN-SYNC),
• the starting time (input of the first SYNC telegram / signal),
• the time between the SYNC telegrams,
• the SYNC correction factor (C0363),
• the operating mode of the FB SYNC1.
Show/Hide Bookmarks