Function library
7-162
L
EDSVS9332P-D21 EN 3.0
7.5.38 Phase-analog converter (CONVPHA)
Three function blocks (CONVPHA1 ... CONVPHA3) are available.
Purpose
Conversion of a phase signal into an analog value.
CONVPHA1
CONVPHA1
CONVPHA1-OUT
C1002
± 199,99%
CONVPHA1-IN
C1001
2
C1000
1
Fig. 7-117 Function block CONVPHA1
Signal
Source Note
Name Type DIS DIS format CFG List
CONVPHA1-IN ph C1002 dec [inc] C1001 3 -
CONVPHA1-OUT a - - - - Limited to ±199.99 %
Function
•
Conversion with adaptation using divisor.
•
The conversion is performed according to the formula:
CONVPHA1–OUT = CONVPHA1–IN ⋅
1
2
C1000
⋅
100%
16384
CONVPHA2
CONVPHA2
CONVPHA2-OUT
C1612
± 199,99%
CONVPHA2-IN
C1611
2
C1610
1
Fig. 7-118 Function block CONVPHA2
Signal
Source Note
Name Type DIS DIS format CFG List
CONVPHA2-IN ph C1612 dec [inc] C1611 3 -
CONVPHA2-OUT a - - - - Limited to ±199.99 %
Function
•
Conversion with adaptation using divisor.
•
The conversion is performed according to the formula:
CONVPHA2–OUT = CONVPHA2–IN ⋅
1
2
C1610
⋅
100%
16384
To Next Page
Loading...
