Function library
7-91
L
EDSVS9332P-D21 EN 3.0
Procedure:
1. A LOW-HIGH edge at POS-ENABLE-TPx
– switches POS-TPx-RECOGN = LOW.
– switches POS-TPx-ENABLED = HIGH.
2. A signal edge at TP input terminal X5/Ex
– switches POS-TPx-RECOGN = HIGH,
– switches POS-TPx-ENABLED = LOW.
3. The actual position at POS-ACTPOS valid at this time is saved in VTPOS at the corresponding
table position.
4. Another LOW-HIGH edge at POS-ENABLE-TPx
– switches POS-TPx-RECOGN = LOW.
– switches POS-TPx-ENABLED = HIGH.
Tip!
The function block POS-TP is part of POS. Therefore it is not necessary to explicitly transfer it to the
processing.
TP positioning has priority over the POS-TP function. When the same TP input is used
simultaneously, TP positioning takes precedence with regard to the TP enable (also see
chapter 7.5.13.4).
To Next Page
Loading...
