Safety instructions
2-2
L
EDSVS9332P-A EN 3.0
Electrical connection
When working on live drive controllers, the applicable national regulations for the prevention of
accidents (e.g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate regulations (e.g. cable
cross-sections, fuses, PE connection). Additional information can be obtained from the
documentation.
The documentation contains information about installation in compliance with EMC (shielding,
earthing, filters and cables). These notes must also be observed for CE-marked controllers. The
manufacturer of the system or machine is responsible for the compliance with the required limit
values demanded by the EMC legislation.
Operation
If necessary, systems including controllers must be equipped with additional monitoring and
protection devices according to the corresponding standards (e.g. law on technical equipment,
regulations for the prevention of accidents, etc.). If necessary, adapt the controllers to your
application. Please observe the corresponding information given in the Instructions.
After the controller has been disconnected from the supply voltage, live components and power
connection must not be touched immediately since capacitors could be charged. Please observe
the corresponding notes on the controller.
All covers and doors must be closed during operation.
Note for UL-approved systems with integrated controllers: UL warnings are notes which apply
to UL systems. The documentation contains special information about UL.
Safe standstill -1-
Variant V004 of the controller series 9300 and 9300 vector, variant x4x of the controller series 8200
vector and axis module ECSxAxxx support the function ”Safe standstill”, protection against
unintentional restart, according to the requirements of Appendix I, No. 1.2.7 of the EC Directive
”Machinery” 98/37/EC, DIN EN 954-1 category 3 and DIN EN 1037. It is absolutely necessary to
observe the information about the function ”Safe standstill” in the corresponding documentation
and instructions.
Maintenance and service
The controllers do not require any maintenance, if the application conditions prescribed are
observed.
In operating areas with polluted ambient air, the cooling surfaces of the controller can get dirty or
the cooling openings can block. Under these conditons a regular cleaning of the cooling surfaces
and cooling openings is essential. Do not use sharp or pointed objects for this purpose!
Disposal
Recycle metals and plastics. Dispose of printed circuit board assemblies according to the state of
the art.
The product-specific safety and application notes in these Instructions must also be
observed!
To Next Page
Loading...
