Content of the 9300 System Manuals
Part Project
planning
Servo
inverter
Servo position
controller
Servo
cam profiler
Servo register
controller
A Contents
Preface and general information
•
• • • •
Safety information
• • • •
B Technical data •
Installation
• • • •
C Commissioning
During operation
• •
• •
User Manual ”Oscilloscope function”
D Configuration D1.1 D2.1 D3.1 D4.1
Code table D1.2 D2.2 D3.2 D4.2
e Troubleshooting and fault elimination • • • •
f DC-bus operation
Operating Instructions for 9340 regenerative
power supply module
•
G Application of brake units
Operating Instructions for 9350 brake unit
•
H Automation
Automation with system bus (CAN)
•
Operating Instructions for 2102 fieldbus
module (RS232/RS485)
•
Operating Instructions for 2111 fieldbus
module (INTERBUS)
•
Operating Instructions for 2131 fieldbus
module (PROFIBUS)
•
Flyer PC software Global Drive Control •
I Accessories and motors •
K How to select the correct drive
Application examples • • • •
L Signal flow diagrams • • • •
M Glossary
Table of keywords
• • • • •
• part of the corresponding System Manual
All documentation listed here contains a type designation and a n identification code at the top left edge.
The features and data of the co ntrolle r specified in your System Manual correspond to the controller version at the time of printing (date of printing: see
inner cover page of the parts).
Lenze strives to keep all information to the state of the latest controller version. If you should still find deviations from your System Manual, we kindly
ask you to refer to the Operating I nstructions included in the scope of supply or to contact your Lenze representative directly.
To Next Page
Loading...
