Function library
7-230
L
EDSVS9332P-D21 EN 3.0
Tif
Tir
Tir
Tif
MPOT1-UP
MPOT1-DOWN
C0260
C0261
0
MPOT1-OUT
Tif
MPOT1-INACT
Fig. 7-178 Deactivation of the motor potentiometer via the input MPOT1-INACT
Initialisation
This function is used to save the output value of the MPOT non-volatile in the internal memory of the
device, when themains is switched off. Thevalue is saved automatically if this function was selected
via the code. When the mains is switched on, the value is reloaded into the MPOT.
C0265 can be used to activate other initialisation functions (see code table).
When the initialisation is completed, the MPOT follows the applied control function.
To Next Page
Loading...
