Function library
7-286
L
EDSVS9332P-D21 EN 3.0
Signal Source Note
Name Type DIS DIS format CFG List
VTPOS-IN1 ph C1351/1 dec [inc] C1350/1 3 -
VTPOS-IN2 ph C1351/2 dec [inc] C1350/2 3 -
VTPOS-IN3 ph C1351/3 dec [inc] C1350/3 3 -
VTPOS-IN4 ph C1351/4 dec [inc] C1350/4 3 -
VTPOS-IN5 ph C1351/5 dec [inc] C1350/5 3 -
VTPOS-IN6 ph C1351/6 dec [inc] C1350/6 3 -
VTPOS-IN7 ph C1351/7 dec [inc] C1350/7 3 -
VTPOS-IN8 ph C1351/8 dec [inc] C1350/8 3 -
VTPOS-IN9 ph C1351/8 dec [inc] C1350/9 3 -
VTPOS-IN10 ph C1351/10 dec [inc] C1350/10 3 -
VTPOS-OUT1 ph - - - - -
... ...
VTPOS-OUT104 ph - - - - -
Function
A total of 104 table positions are available.
•
Enter fixed target position values via C1301/x.
– 60 table positions (VTPOS-No1 ... VTPOS-No60) are available.
– Subcodes (C1301/1 ... C1301/60) define the table position number.
•
Enter variable target position values via VTPOS-INx.
– 10 table positions (VTVEL-No61 ... VTVEL-No70) are available.
– Signal input via function blocks.
– The target position value must be transmitted to the table positions before the
corresponding program set starts and accesses these values.
•
Enter target position values of FB TEACH1.
– 30 table positions (VTPOS-No71 ... VTPOS-No100) are available.
•
Enter target position values via touch probe.
– 4 table positions (VTPOS-No101 ... VTPOS-No104) are available.
•
C1380 displays the target position values (in units) on the table positions.
– Select table position (C1380/1 ... C1380/104) with subcode.
•
C1381 displays the target position values (in inc) on the table positions.
– Select table position (C1381/1 ... C1381/104) with subcode.
•
The conversion from target position [units] to target position [inc] is performed according to
the formula:
Target position [inc] = Target position [units] ⋅
65536 [inc∕r] ⋅ gear nominator
Feed const. [units∕r] ⋅ gear denominator
Tip!
Entries into the processing table are only required if FB inputs are used.
To Next Page
Loading...
