Starting the engine for driving / switching it off
4.1 Starting the engine from the driver's cab
Operating Instructions GMK5250L 3 302 633 en 4 - 13
27.09.2017
4.1.8 Display – setting the brightness
The brightness of the displays is regulated automatically by the CCS,
depending on the ambient brightness. You can set a minimum degree of
brightness manually, which is always observed when the brightness is
regulated.
H
Depending on the program version, the brightness of the headlight is
reduced to 40% regardless of the minimum brightness setting, but can be
increased again manually at any time.
• Open the Settings menu (1).
• Select and confirm the symbol (1).
• Set the desired brightness on the display (2).
• Confirm the selection.
The brightness of the display changes while
setting and you can view the set value (0 to
100%) on the display (2) or (3).
The brightness set here is the minimum value
for automatic regulation.
H
There is no automatic regulation if you set the brightness to 100%.
The displays then always show maximum brightness.
You can cancel the entry at any time using buttons (1) or (2). The settings
are then reset.
If the temperature on the display is too high, the brightness is reduced auto-
matically – lamp (1) lights up.
When the temperature falls, the specified brightness is restored – lamp (1)
goes out.
To Next Page
Loading...
Need help?
General
