Rigging work
11.5 Starting the engine for driving for rigging work
Operating Instructions GMK5250L 3 302 633 en 11 - 23
27.09.2017
11.5 Starting the engine for driving for rigging work
The engine for driving must be running for rigging work, e.g., to move the
outriggers. You can start the engine for driving:
– With the hand-held control,
– From the control units of the outriggers.
H
You can generally start the engine only if a bridging plug is inserted in all
sockets not required.
11.5.1 Starting/turning off the engine with the hand-held control
Prerequisites The following requirements must be met before you can start the engine for
driving with the hand-held control:
– The ignition is switched off in the crane cab.
– The ignition is switched off in the driver's cab.
• Connect the hand-held control to a socket on the carrier; à p. 11 - 22.
s
To Next Page
Loading...
Need help?
General
