Rigging work
11.11 Other rigging work
Operating Instructions GMK5250L 3 302 633 en 11 - 137
27.09.2017
11.11.5 Cameras for crane operation
Camera on
main boom
For crane operation you have to install the camera and switch it on.
For on-road driving, you have to switch the camera off again and remove it.
The camera (1) may only be installed on a
truck crane equipped with the appropriate
receiver (2). The camera and receiver are
coordinated and identified with the same
number on the model plate.
• Before installation, compare the numbers
on the model plates.
• Switch off the ignition in the crane cab.
s
G
Risk of accidents if the wrong camera is installed!
If you install the wrong camera in your truck crane, you will not see an
image.
If your camera is installed in a neighbouring truck crane, you will see the
wrong image.
G
Risk of accidents due to a falling camera!
Always use a retaining pin to hold the camera in the clamp.
This prevents the camera falling down and injuring someone.
To Next Page
Loading...
Need help?
General
