Driving modes and rigging for on-road driving
6.5 Installing/removing the outrigger beams
Operating Instructions GMK5250L 3 302 633 en 6 - 47
27.09.2017
6.5.9 Unscrewing/screwing in the spacers
There are two spacers for each outrigger beam
– In the outrigger box
– In the outrigger beam on the opposite side.
The illustrations show as an example the spacers for the outrigger beams
on the front left hand side.
Unscrewing Before you pull out the outrigger beams, you must unscrew the spacers.
At the outrigger box
• Loosen the nuts (2).
• Unscrew the bolts (1) until the spacers (3)
are screwed into the outrigger box (4) com-
pletely.
At the outrigger beam
• Loosen the nuts (2).
• Unscrew the bolts (1) until the spacers (3)
are screwed into the outrigger box (4)
completely.
s
To Next Page
Loading...
