Crane operation
10.6 Settings and displays for crane operation
10 - 126 3 302 633 en Operating Instructions GMK5250L
27.09.2017
10.6.7 Setting the characteristic curves for the control levers
The control lever characteristic curve determines how high the power unit
speed should be for a particular control lever movement.
You can assign different control lever characteristic curves to the power
units.
• Open the Settings menu (1).
The symbols (2) show the set characteristic
curves of the power units (1).
• Select the power unit for which you would
like to change the characteristic curve.
• Set the desired characteristic curve.
Select and confirm symbol (3) to reset all
power units to characteristic curve 1.
There are five characteristic curves:
The higher the number of the characteristic
curve (1) to (5), the further the control lever
must be moved to get a clear increase in
speed.
With characteristic curve (5), you can work
particularly sensitively with the control lever.
To Next Page
Loading...
Need help?
General
