Malfunctions during crane operation
14.4 Finding and eliminating malfunctions
Operating Instructions GMK5250L 3 302 633 en 14 - 15
27.09.2017
14.4.4 Malfunctions in the main boom camera
Malfunction Cause Remedy
No image appears on the
monitor after it is switched
on.
Fuse on the crane cab blown Replace the blown fuse;
à p. 14 - 63.
Fuse blown – in camera or
monitor.
Check fuses and replace as
necessary;
à Manufacturer’s
operating manual
.
Radio communication
between camera and receiver
is interrupted.
Adjust the receiver on the crane
cab.
Connection between receiver
and monitor is disconnected.
Check cable connection and
notify
Manitowoc Crane Care if
necessary.
To Next Page
Loading...
Need help?
General
