Driving
5.2 Operating the transmission
5 - 28 3 302 633 en Operating Instructions GMK5250L
27.09.2017
For reverse travel
The reverse camera is switched on.
The display (1) shows the area behind the truck crane.
When you exit the transmission mode R, the camera is switched off and the
display (1) shows the CCS menu.
Selecting the
starting gear
You can also change the gear that is automatically selected on starting.
H
Only change the gear selected on starting if it is absolutely necessary to do
so. Starting is a gear that is too high causes premature clutch wear.
• Pull the gearshift lever upwards once.
The starting gear is shifted up by one gear.
• Press the gearshift lever downwards once.
The starting gear is shifted down by one gear.
The altered starting gear is shown on the display.
By changing the starting gear, you also change the transmission over to
Manual operating mode at the same time. For on-road driving, you should
switch over to
Automatic operating mode.
To Next Page
Loading...
Need help?
General
