Rigging work
11.11 Other rigging work
Operating Instructions GMK5250L 3 302 633 en 11 - 135
27.09.2017
Inspecting/replac-
ing safety harness
The safety harness on the main boom must be inspected for damage at
regular intervals.
Inspection
• Check all fastening and connecting parts for
damage, wear, mobility and deformations.
Replacement
Make sure damaged, worn, or deformed fas-
tening or connecting parts are immediately
replaced by
Manitowoc Crane Care or an author-
ised GROVE dealer or your repair crew.
H
The safety harness must always be replaced completely following stress
caused by a fall, even if no damage can be detected.
H
Make sure your personal protective equipment is also regularly inspected.
In order to do this, observe the information provided by the manufacturer.
G
Risk of accidents if inspections are not carried out!
Make sure the safety harness is inspected regularly.
This will prevent component failure in cases of danger.
A safety harness only ensures protection from falling if it is regularly
inspected.
To Next Page
Loading...
Need help?
General
