Driving with a rigged truck crane
12.3 Before driving
Operating Instructions GMK5250L 3 302 633 en 12 - 7
27.09.2017
Aligning the truck crane
• Retract the support cylinders until they do not make contact with the
ground during alignment.
• Level the truck crane with the Raise axle
function.
–On the
Current inclination display, the
marking (1) must be in the middle of
the 1° measuring range.
– The displays (2) must show an even axle
load.
à Operating the axle raising system, p. 11 - 63.
To secure the truck crane
• Retract the outrigger cylinders until the outrigger pads are about 5 to
10 cm (2 to 4 in) above the ground. Leave the outrigger beams extended.
G
Danger of overturning if outriggers are retracted!
Always leave the outrigger beams extended and the outrigger pads just
above the ground to secure the truck crane against overturning.
To Next Page
Loading...
