Minebea Intec X3 - Page 158

Input of the limit 2: In weight, unit same as Max,
transition from small to medium scale interval
Only for [Multiple range] or [Multi-interval]!
— View (when CAL-switch is closed)
— Max Display only
— Scale interval Display only
— Dead load at Display only
— Max at Display only
— Calibrated at Display only
— Sensitivity (µV/d) Display only
— Param Items as for [Param] (display only)
— Setup Setup of the xBPI scale
— Calibration Calibration of xBPI scale
— Dead load Dead load/preload
— Set Set dead load/preload: Accept, ResError, Abort
— Delete Clear dead load/preload: Accept, ResError,
Abort
— Span
— Calibrate with user
weight
— Calibrate with auto
weight
— Adjust with default
weight
Calibrate with standard weight.
— Adjust with internal
weight
Calibrate with internal weight.
— Linearity Setting linearity.
— Default Resetting the Device to the Factory Settings:
Accept, ResError, Abort
— User User defined settings: Accept, ResError, Abort
— Configuration Configuration of the scale
— Weighing parameters Weighing parameters
— Ambient conditions Select environmental conditions: Very stable,
stable, unstable, very unstable
— Application filter Select application filter: Final readout, Filling
mode, Low filtering, w/o filtering
— Standstill range Select standstill range: 0.25 igit, 0.5 digit,
1 digit, 2 digit, 4 digit, 8 digit
— Stability symb. delay Select Stability delay: no delay, short delay,
average delay, long delay
— Tare parameter Select taring: at any time, not until stable
— Auto zero function Auto-Zero: auto zero on, auto zero off
— Adjustment function Adj. sequence: ext.adj.w.fact.wt.,
ext.adj.w.user.wt., ext.adj.w.pres.wt., internal
adjust, ext.lin.w.fact.wt., ext.lin.w.user.wt.,
confirm preload, delete preload, adjust
disabled
— Confirming adjust. Confirm calibration: manual, automatically
— Zero range Zero point range: 1% of max load = 1%/Max.
load, 2% of max load = 2%/Max. load, 5% of
7.13.7.2 "xBPI scale" weighing point
Calibrate with user-defined weight.
Calibrate with automatic weight detection.
X3 Process Indicator PR 5410 7 Getting started
EN-156 Minebea Intec