Minebea Intec X3 - Page 68

Switch settings Configuration
ON: S3, S4, S5
OFF: S1, S2
- [Serial ports parameter]- […]- [Slot 1/2 RS485]
Note:
For more information on the switch settings, see Chapter 4.6.3.2.
4.6.3.2.2 RS-485 point-to-point connection (2-wire)
2-wire transfer mode:
Half duplex (simultaneous sending and receiving not possible)
Switch settings Configuration
ON: S1, S2, S3, S4, S5
OFF: …
- [Serial ports parameter]- […]- [Slot 1/2 RS485]
Note:
For more information on the switch settings, see Chapter 4.6.3.2.
X3 Process Indicator PR 5410 4 Device installation
EN-66 Minebea Intec