Switch for input PR 5510/09 block diagram
Factory setting:
S102
Factory setting:
S101
An external power supply is required: PIN 1 (Uext), reference po-
tential PIN 26 (GND)
4.6.8.1 Outputs
The outputs for PR 5510/09 (PIN 2…24) work as a reference potential and open collectors
with a shared ground.
A non-active output is highly resistant.
A voltage of 0.9 V is applied to an active output via GND.
The load to be connected is between the outputs (PIN 2…24, 25) and Uext (PIN 1).
4 Device installation X3 Process Indicator PR 5410
Minebea Intec EN-87
To Next Page
Loading...
