Hold/Transfer/During Conversation
¾ 4-25 ¾
u
Attendant Reverting
DESCRIPTION:
When hold transfer is failed because the destination telephone did not answer and returned back to
originating telephone, then the originating telephone did not answer, the next action is selected by
system data (Program #19-E) as follows:
1) The call will be cut off by pre-set timer (Program #29) is over.
2) The call will be transferred to the Attendant Telephone.
Attendant Telephone: TX-Z 1232/2464 The pair extension of DSS console, extension No.10 or
operator station of each tenant
TX-Z 824 Extension No.10 or operator extension of each tenant
TX-Z 308 Extension No.10
This timer (Program #29) will be activated as below condition.
1. Put an outside call on System Hold.
2. Announced Transfer Recall timer is released.
3. Unannounced Transfer Recall timer is released.
4. Exclusive Hold Recall timer is released.
STATION APPLICATION:
KTS, SLT
OPERATION:
Not applicable.
RELATED SYSTEM DATA:
#08-D: Tenant Group
#19-E: SLT Hold Transferring
#29: Attendant Reverting
#52: Tenant Feature
#54: Tenant Attendant
#62: DSS Console Port Assignment
u
Recall Trunk Display
DESCRIPTION:
Executive telephone can be set to the Recall Trunk Display Mode. When Hold Recall tone is heard, the
telephone will display the held Trunk line and the telephone number.
STATION APPLICATION:
KTS with LCD
OPERATION:
To set/reset:
1. Press SPK key.
2. Press ICM key. (TX-Z 824/1232/2464 only) (See Note)
3. Press OPAC key.
4. Press CHECK key.
Note : If Program #75-D is 0 (No tone), skip Step 2. (TX-Z 824/1232/2464)
RELATED SYSTEM DATA:
Not applicable.
To Next Page
Loading...