Nitsuko 1232 - Installation of TX-Z 824 System Table of Contents

Table of Contents
Installing the Main Equipment....................................................................... 3-2-1
The Card Locations....................................................................................... 3-2-2
Grounding Requirements.............................................................................. 3-2-2
Connector Assembly..................................................................................... 3-2-3
Trunk Line Connection.................................................................................. 3-2-3
Extension Connection ................................................................................... 3-2-4
Cable Routing and Cramping........................................................................ 3-2-5
Installing Expansion PCBs............................................................................ 3-2-5
Installing DLS Console.................................................................................. 3-2-5
Installing the Ringer Unit............................................................................... 3-2-6
Installing the SMDR and Printer/PC ............................................................. 3-2-6
Installing 4PFU-A1 PCB................................................................................ 3-2-7
Installing 8DHEXU-A1 PCB .......................................................................... 3-2-7
Installing the Doorphone Box........................................................................ 3-2-8
Installing External Paging Output ................................................................. 3-2-9
Installing External MOH and BGM..............................................................3-2-10
Installing External Alarm Sensor................................................................. 3-2-11
Lithium Battery Installation..........................................................................3-2-11
Backup Battery Connection ........................................................................ 3-2-12
Note: Refer to PART 7-1 for installation of 8SMCID-A1