Trunk Outgoing Call
¾ 4-1 ¾
n
nn
n Specified Trunk Access
DESCRIPTION:
Trunk (CO/PBX) lines can be grouped into a maximum of 30 groups. The line groups assigned to each
extension can be used for outgoing calls. Up to two outgoing line groups can be assigned to an
extension. An extension user can place outside calls on a particular line group by pressing Line key or
dialing line number.
STATION APPLICATION:
KTS, SLT
OPERATION:
To make an outside call on a particular line:
<KTS>
When the trunk line appears under a Line key:
1. Lift handset or press SPK key.
2. Press a Line key. Hear dial tone.
3. Dial telephone number.
When the trunk line does not appear under a Line key:
1. Lift handset or press SPK key. (See Note 1)
2. Dial 9 (TX-Z 824/1232/2464).
Dial 90 (TX-Z 308).
3. Dial two-digit line number. Hear dial tone.
4. Dial telephone number.
<SLT>
1. Lift handset. Listen for dial tone.
2. Dial 0 or 9. (See Note 2)
3. Dial two-digit line number. Hear dial tone.
4. Dial telephone number.
Note 1: If Program #75-D is 0 (No tone), press ICM key after Step 1 to seize Intercom. (TX-Z 824/1232/2464)
Note 2:
Program #20-D Data Automatic Trunk Access Code for SLT Dial at Step 2
009
190
Note 3: Easy Trunk Access, Queuing Group Access, Loop Key Trunk Access, Automatic Off-Hook Trunk Access
features provide other ways to access a Trunk Line.
RELATED SYSTEM DATA:
#02: Line Group Assignment
#03-C: Common Use Line Assignment
#06: Outgoing Line Access
#75-D: KTS Off-Hook Mode Selection
u
Single Step Access
DESCRIPTION:
Single Step Access allows a key telephone user to obtain outside or intercom dial tone for an outgoing
call in a single step, without lifting the handset or pressing the SPK key.
STATION APPLICATION:
KTS
To Next Page
Loading...