EasyManua.ls Logo

Nitsuko 1232 - Leave a Telephone Number

Default Icon
388 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
¾ 7-3-3-8 ¾
Features on DISA
RELATED FEATURES:
Direct Inward System Access (DISA)
n
nn
n Leave a Telephone Number
This feature is available when desired extension is
only KTS with Display
.
DESCRIPTION:
On the Extension Access feature in DISA, when outside caller calls to extension which is set to Absent
Mode, outside caller can leave Telephone Number using DTMF after outside caller hears Absent
Message (Personal Message) that extension user left and VAU Message (No. 07: Demanding Message
for Leave a Message or Leave a Telephone Number). After sending Absent Message and VAU Message,
system sends Starting Message (No. 12: Starting Message for Leave a Message). Outside caller can
leave a Telephone Number and dial #. When outside caller finished dialing, system sends Ending
Message (VAU Message No. 14: Ending Message for Leave Telephone Number). Absent Mode
extension user can confirm, and callback the left Telephone Number's party by easy operation after
coming back to the desk.
On the intercom call, when the other extension called to Absent Mode extension, system sends Absent
Message and Busy Tone. Called extension can not use Intercom Camp-On and Intercom Off-Hook
Signaling features.
Maximum digits that outside caller can leave are 16 digits. If there are some PBX lines which are
connected to system, maximum digits are 14 or 15. (Digits are according to "PBX Access Code in
Program #38"). Maximum 64 telephone numbers are stored at system. When system power is in OFF
condition, all Personal Messages and left Telephone Numbers are erased. When there are some
Telephone Numbers that outside caller left, MW lamp/Indicator flashes as follows at Absent Mode
extension.
- KTS with Display(TXD): MW lamp 0.1 sec. ON/0.1 sec. OFF
- KTS with Display(BTXD): Indicator 0.1 sec. ON/0.1 sec. OFF
STATION APPLICATION:
KTS with Display
OPERATION:
To set Absent Mode:
Display Indication Operation and Information
##SUN# 25# 12:00PM
1. Lift handset or press SPK.
2. Press ICM key. (See Note)
3. Press TRFR.
##SUN# 25# 12:00PM
##############12
4. Dial
own
extension number.
(For Example: Extension No. 12)
##SUN# 25# 12:00PM
12##############
5. Hang up or press SPK. (TRFR key will flash.)
Note : When Program #75-D is 0 (No tone), skip Step 2.

Table of Contents

Related product manuals