¾ 7-3-3-29 ¾
Other Features
To erase all General Messages
at receiving extension
:
Display Indication Operation and Information
(KTS)
1. Lift handset or press SPK.
2. Press ICM key. (See Note 1)
3. Dial
*
, 0, #. (see Note 2)
4. Hang up or press SPK.
(SLT)
1. Lift handset.
2. Dial 68. (Dial Plan 1) (see Note 2, 3)
or
2. Dial 058 (958). (Dial Plan 2) (see Note 2, 3)
3. Hang up.
Note 1: When Program #75-D is 0 (No tone), skip Step 2.
Note 2: This operation is a same canceling operation as
Message Waiting, Leave a Message and Leave a
Telephone Number features. When this operation
has been done, all the features which had been set
will be canceled, and MW lamp/Indicator will go off.
Note 3: When messages are erased, Dial Tone may be sent.
To go off the MW lamp/Indicator: (This operation is available
only KTS
.)
Display Indication Operation and Information
(On Hook condition)
1. Press OPAC.
2. Press CLEAR.
RELATED SYSTEM DATA:
Not applicable
RELATED FEATURES:
Not applicable
n
nn
n Unattendant Message (Automated Attendant for normal incoming)
DESCRIPTION:
On the ordinary incoming calls, when nobody answered within the time which was set in Program #65, the
system automatically answers and sends an Unattendant Message (VAU Message No. 24: Unattendant
Message) to outside caller, and this line is put on hold. I-HOLD mode is automatically set at operator's
extension (Program #51). If nobody answered to held line within the time which was set in Program #65,
the system sends the VAU Message (No. 05 Cut-Off Message) to the held line (outside caller), and the
line will be cut off forcibly.
On the ordinary incoming calls, when a user is making conversation with outside party, the extension user
can send the Unattendant Message to this line and this line is put on hold before the Program #65 timer is
over. I-HOLD mode is set at the extension in this case.
To Next Page
Loading...