Hold/Transfer/During Conversation
¾ 4-29 ¾
n
nn
n Long Conversation Warning (Three Minutes)
DESCRIPTION:
Long Conversation Warning is a signal reminder that sounds every three minutes while an extension is
on an outgoing outside call. The signal reminder is a series of three short tones that sound over the
speaker of the phone.
STATION APPLICATION:
KTS
OPERATION:
Not applicable.
RELATED SYSTEM DATA:
#18-A: Three Minutes Warning Tone
n
nn
n Long Conversation Cut-Off
DESCRIPTION:
A conversation on an external call (only Outgoing Call) can be forcibly terminated by the system after a
pre-programmed period has lapsed. Before terminating the call, a warning tone (400 Hz continuous tone)
will be sent to the caller within a pre-programmed period. This feature is enabled or disabled on an
extension basis.
This feature permits the restriction of long conversations on certain extensions.
STATION APPLICATION:
KTS, SLT
OPERATION:
Not applicable.
Note 1: “Conversation Timer” (Program #82-1) will be activated even if the assigned extension places an outgoing
call then transfers that Trunk line to another extension. (Conversation Timer will also be activated even if
transferred extension is set to 0 by Program #75-E.
Note 2: In the event of Multi-line Conference being established by the assigned extension, only outgoing Trunk line
will be forcibly terminated after the pre-programmed period has lapsed. The conversation between
Incoming Trunk line and the assigned extension will still be maintained.
RELATED SYSTEM DATA:
#75-E: Long Conversation Cutoff
#82: Long Conversation Cutoff Timer
n
nn
n Break-In
DESCRIPTION:
Break-In lets an extension user override the system's privacy feature - a key telephone user can break
into an outside call at another extension, including a call on a Private Line. The intrusion may or may not
be preceded by a warning tone, depending on programming (Program #-04-A), and the warning tone
comes over the speaker of both extensions. A warning intrusion tone can be sent in every 2 seconds by
programming (Program #78-C).
STATION APPLICATION:
KTS
OPERATION:
1. Lift handset or press SPK key.
2. Press steadily lit Line key. This breaks into the telephone conversation on that line.
To Next Page
Loading...