Intercom Outgoing Call
¾ 4-38 ¾
STATION APPLICATION:
KTS, SLT
OPERATION:
<KTS>
1. Lift handset. (See Note 1)
2. Dial # (TX-Z 824/1232/2464).
Dial 86 (TX-Z 308).
3. Dial Hunting Group No. (0 - 4)
- The first idle extension is called. If the extension does not answer in the preprogrammed time, the
system calls the next idle extension, or the caller can dial # to call next idle extension.
<SLT on Dial Plan 1>
1. Lift handset.
2. Dial 7, and wait for dial tone.
3. Dial #.
4. Dial Hunting Group No. (0 - 4)
- The first idle extension is called. If the extension does not answer in the preprogrammed time, the
system calls the next idle extension, or the caller can dial # to call next idle extension.
Note 1 :If Program #75-D is 0 (No tone), press ICM key after Step 1 to seize Intercom (TX-Z 824/1232/2464).
Note 2: SLT on Dial Plan 2 can not use this feature.
Note 3: When Program #80-2-A = 1, the extension of the first order no. is called after the extension of the last order
no. is called first. If the Hunting Group calling timer expires, Group Hunt is used again, or Step Call (pressing
#) is used.
RELATED SYSTEM DATA:
#11: Hunting Groups
#84: Hunting Group Calling Timer
#80-2-A: Group Hunt Mode
n
nn
n Step Calling
DESCRIPTION:
When an extension user makes an Intercom call and receives a busy signal or no answer, Step Calling
lets the user call the other extensions, in ascending order, by just dialing a code. For example, if
extension 12 is busy, Step Calling tries extension 13. If there is no answer at extension 13, Step Calling
tries extension 14, and so on. Step Calling is canceled if it reaches an extension that is not installed.
STATION APPLICATION:
KTS, SLT
OPERATION:
1. Place Intercom call.
- Receive busy tone or no answer.
2. Dial #.
- Next extension is automatically called. To call the next extension, dial # again.
RELATED SYSTEM DATA:
Not applicable.
To Next Page
Loading...