Other Trunk Features
¾ 4-33 ¾
n
nn
n Unsupervised Conference
DESCRIPTION:
Unsupervised Conference allows an extension user to establish a Conference with two outside parties,
then hang up, leaving the outside parties connected. The extension user can later join the Unsupervised
Conference if desired. The system can accommodate up to four Unsupervised Conference at a time, and
each
Unsupervised Conference must be assigned an unused extension port in Unsupervised
Conference Port Assignment (program #05),
and Multi-Line Conference must be enabled in
programming.
STATION APPLICATION:
KTS
OPERATION:
To establish an Unsupervised Conference:
1. Establish first outside call.
2. Press CONF key. The call is put on Hold.
3. Establish second outside call.
4. Press CONF key.
- Three-party Conference is established.
5. Press CONF key.
- Both outside parties are put on Hold.
6. Hang up.
- Unsupervised Conference is established.
To later join an Unsupervised Conference:
1. Lift handset.
2. Press either Line key of the Conference.
To terminate:
1. Establish Three-party Conference.
2. Hang up.
- Both outside lines become idle
Note: When both outside parties finish the call, unsupervised conference must be manually terminated by
the telephone which sets up the call.
RELATED SYSTEM DATA:
#05: Unsupervised Conference Port Assignment
#16-E: Multi-Line Conference
n
nn
n Call Timer
DESCRIPTION:
Call Timer is an automatic stopwatch feature that timer outgoing outside calls on Display phones. The
display changes to a stopwatch at the programmed Call Duration Start Time and the timing stops when
the extension user hangs up. The display shows the duration of the call for approximately eight seconds,
then changes to the date and time.
STATION APPLICATION:
KTS with LCD
OPERATION:
Not applicable.
RELATED SYSTEM DATA:
#25: Call Duration Start Time
To Next Page
Loading...