Other Features
¾ 4-79 ¾
u
Call Charge Output to SMDR
DESCRIPTION:
When the room status is changed to Maid Required, the system automatically outputs the call charge
(total charge) of the associated extension to SMDR (Station Message Detail Recording) reports. The
outside calls made after Room Status of the extension is set to Check In and until set to Maid Required
are charged. The call charge after Room Status of the extension is set to Check In and up to the present
can be output to SMDR manually. The Call Charge data remains and can be output until next Check In
operation. The dials which match the code stored in Charge Code Table are charged according to the
corresponding charge rate. A maximum of 50 codes (1- 4 digits) can be entered in the Call Charge Table.
Optional (charge in one minute increment) or fixed (charge per call) rate is applied on a Trunk line basis.
If the total charge exceeds the maximum call charge assigned in Program #98, the system sets Dial
Block to prohibit outside calls from that extension.
24SMDR-A1 or 24SMCID-A1 is required for SMDR feature.
SMDR Output Example
CLS DATE TIME LINE DURATION ST# DIALED# RING ACCT NO.
OTG 30/07/98 14:06:50 01 00:04:09 11 0312344568
TOTAL CALL CHARGE TEL NO.: 011 CALL COUNT: 001 TOTAL 00100
Note: The total charge is output with or without a decimal point (for auxiliary currency unit). The possible maximum
value of total charge is 999999, or 9999.99. If the total charge exceeds the maximum value, the maximum
value is output.
STATION APPLICATION:
KTS, SLT (Depending on Program 80-2-B)
OPERATION:
To output Total Call Charge of an extension manually:
<KTS>
1. Lift the handset or press SPK key.
2. Press ICM key. (See Note1)
3. Dial
*
, #,
*
.
4. Dial the extension No. to output the call charge. (e.g. 18)
5. Dial 6.
6. Hang up.
<SLT on Dial Plan 1>
1. Lift handset.
2. Dial 67.
3. Dial the extension No. to output the call charge. (e.g. 18)
4. Dial 6.
5. Hang up.
To Next Page
Loading...