Intercom Outgoing Call
¾ 4-36 ¾
n
nn
n Direct Station Selection
DESCRIPTION:
Direct Station Selection (DSS) provides an extension user with one-button access to other extensions in
the system. Each of the ten One-Touch keys on a key telephone can be programmed to call a particular
extension. The One-Touch keys can also be programmed to access any Page Zone (see Paging) or
Doorphone using the steps below.
STATION APPLICATION:
KTS
OPERATION:
To program a One-Touch key for DSS:
1. Lift handset.
2. Press ICM key. (TX-Z 824/1232/2464 only) (See Note)
3. Press DC.
4. Dial #.
5. Press One-Touch key.
6. Dial extension number.
or
to program a Page Zone, dial 80-87. (80 - 85 for TX-Z 308)
to program a Doorphone, dial 88 or 89.
7. To program more keys, repeat steps 3-6.
8. Hang up.
Note : If Program #75-D is 0 (No tone), skip Step 2. (TX-Z 824/1232/2464)
To use a DSS key:
1. Lift handset. If Single Step Access is programmed and the phone is equipped with a Speakerphone,
this step can be skipped.
2. Press One-Touch key set as DSS key.
To hold and transfer a Trunk call using a DSS key:
- Make conversation with an outside party.
1. Press a desired One-Touch key set as DSS key.
- The Trunk line will automatically be held, then intercom call will be established.
2. Make announcement (if desired).
3. Press TRFR key or hang up to transfer.
To display the number programmed under a DSS/One-Touch key:
- Do not lift handset.
1. Press CHECK key.
2. Press ICM key.
3. Press One-Touch key.
- Key number displays, then stored number.
4. Press CLEAR to return to normal display.
On TX-Z 308 System, One-Touch Key No.1 to No.8 are initially programmed as DSS keys for Extension
No.10 to No.17, One-Touch Key No.10 for All Call Paging (80).
On TX-Z 824/1232/2464 System, One-Touch Key No.1 to No.9 are initially programmed as DSS for
Extension No.10 to No.18, One-Touch Key No.10 for All Call Paging (80).
RELATED SYSTEM DATA:
Not applicable.
To Next Page
Loading...