Nitsuko 1232 - General Description; Required Items and Capacity

¾ 7-1-1 ¾
General Description
Caller-ID feature provides a caller's telephone number and/or name with time and date on the
display of Key Telephone. You can check the caller's information before answering the incoming
call. TX-Z Series can be support this feature by using additional items which are newly developed.
Note:
This feature is available
only for the Key Telephone with Display
. Standard type Key
Telephone (No Display) and Single Line Telephone are not supported.
Required Items & Capacity
Required items and System Capacity are as follows;
TX-Z 308
Items QTY Required Items Software Version
Caller-ID Line 3 NX7E-3CIDU-A1 V2.0 or upwards
Unit Name Description
NX7E-3CIDU-A1 Caller-ID Interface unit for 3 Trunk Lines
TX-Z 824
Items QTY Required Items Software Version
Caller-ID Line 8
NX7E-8SMCID-A1 ´ 1
NX7E-8CID ADAPTOR ´ 1
V3.1 or upwards
NX7E-8SMCID-A1 used for SMDR feature and Caller-ID Adaptor connection
NX7E-8CID ADAPTOR 8 detection circuits for the Caller-ID Data
Note: NX7E-8SMCID-A1 PBA must be installed instead of NX7E-8SMDR-A1 PBA.
TX-Z 1232/2464
Items QTY Required Items
Caller-ID Line 24
NX7E-24CPU-B1 ´ 1
NX7E-24SMCID-A1 ´ 1
NX7E-8CID ADAPTOR ´ 3
NX7E-24CPU-B1 New CPU card (including the Caller-ID feature)
NX7E-24SMCID-A1 used for SMDR feature and Caller-ID Adaptor connection
NX7E-8CID ADAPTOR 8 detection circuits for the Caller-ID Data
Note 1: NX7E-24CPU-B1 PBA must be installed instead of NX7E-24CPU-A1 PBA.
Note 2: NX7E-24SMCID-A1 PBA must be installed instead of NX7E-24SMDR-A1 PBA
.