Trunk Outgoing Call
¾ 4-11 ¾
<SLT on Dial Plan 1>
1. Lift handset.
2. Dial Queuing Group number (1-4).
<SLT on Dial Plan 2>
1. Lift handset.
2. Dial 06 or 96 (refer to #20-D)
3. Dial Queuing Group number (1-6)
Note 1: If Program #75-D is 0 (No tone), skip Step 2. (TX-Z 824/1232/2464)
RELATED SYSTEM DATA:
#01-C: Queuing Group - Line Assignment
#15-C: Automatic Trunk Access
#20-D: Automatic Trunk Access Code for SLT
#64-C: Trunk Line Seizing Order Selection
n
nn
n Automatic Repeat Dialing
DESCRIPTION:
If an extension user places a trunk call that is busy or unanswered, they can have Automatic Repeat
Dialing try it again later on. The user doesn't continually have to try the number again -- hoping it will go
through. Automatic Repeat Dialing automatically retries it until the called party answers. Moreover, while
Automatic Repeat Dialing is set (waiting, busy or no-answer), Hurry-Up operation can be taken place for
immediate redial.
While Automatic Repeat Dialing is set (waiting condition), 2-Splash tone (Mute-tone) is emitted from
built-in speaker in 5 sec cycle.
STATION APPLICATION:
KTS
OPERATION:
To use Automatic Repeat Dialing:
1. Place outside call.
- Listen for busy tone or ring-no-answer.
2. Press OPAC key.
3. Dial 1.
4. Replace handset or press SPK key.
- The system periodically redials the call.
To cancel Automatic Repeat Dialing:
1. Lifting the handset cancels Automatic Repeat Dialing.
To use Hurry-Up operation
1. Press OPAC key.
2. Dial 2.
Repeat Dialing and Hurry-Up Operation can be stored under One-touch key.
On TX-Z 308 system, One-Touch Key No.09 is initially set as Automatic Repeat Dial key.
RELATED SYSTEM DATA:
#01-C: Queuing Group - Line Assignment
#33: LND/Repeat Dial Hooking Time
#34: Repeat Dial Timers
To Next Page
Loading...