Hold/Transfer/During Conversation
¾ 4-26 ¾
n
nn
n Park Hold (TX-Z 824/1232/2464)
DESCRIPTION:
This feature permits transferring of a call placed on temporary hold on a Park Hold key. It is used to
transfer an outside call to KTSs that do not appear under a key in order to answer a call on that line. Park
Hold key can be assigned on Line keys. The system has four Park Hold groups. An extension can be
assigned to only one Park Hold group. A line group can contain any number of lines. An extension user
can answer a call placed on Park Hold only if the extension is in the same Park Hold group. If the line
seized by Loop key is put on Park Hold, the Loop key’s LED goes off, and an idle Trunk line can be
seized by pressing the Loop key.
STATION APPLICATION:
KTS
OPERATION:
To place a call on Park Hold:
- While on an outside call.
1. Press Park Hold key.
To answer a call on Park Hold:
1. Lift handset.
2. Press Park Hold key.
To answer a call on I-Hold (the call placed on System Hold or Exclusive Hold by the extension user itself)
in case the line which does not appear under Line key is held:
1. Lift handset.
2. Press ICM key. (TX-Z 824/1232/2464 only) (See Note)
3. Press OPAC key.
4. Dial 3.
Note : If Program #75-D is 0 (No tone), skip Step 2. (TX-Z 824/1232/2464)
RELATED SYSTEM DATA:
#08-E: Park Hold Group
#55: Park Hold Key Assignment
n
nn
n Conference
u
Add-On Conference
DESCRIPTION:
Add-On Conference lets an extension user establish an outside call and then add up to five other inside
parties to the conversation. If Multi-Line Conference is enabled in programming, a second outside call
can be added to the conversation.
STATION APPLICATION:
KTS, SLT
To Next Page
Loading...