Nitsuko 1232 - SMDR Printout Format

List of SMDR Printout Data
¾
4-112
¾
B: Incoming call answer (INC)
- When Program #57-E is assigned "1", input account code.
- When conversation is transferred while Program #57-B is assigned "1", extension number of last
conversation is printed-out.
- When Caller-ID Unit is installed and Program #58-D is assigned other than “0”, caller’s data
(Telephone Number and/or Name) is printed out.
C: Incoming call no answer (INC)
- Program #57-C is assigned "0".
- When Caller-ID Unit is installed and Program #58-D is assigned other than “0”, caller’s data
(Telephone Number and/or Name) is printed out.
D: Transfer of outgoing call line (OTR)
- Program #57-B is assigned "0".
- The telephone must be assigned by Program #61-D = “0” (Printed)
- When transferred outgoing call line is transferred again, or when transferred outgoing call line cuts
off, these Data will be printout.
E: Transfer of incoming call line (ITR)
- Program #57-B is assigned "0".
- When transferred incoming call line is transferred again, or when transferred incoming call line cuts
off, these Data will be printout.
F: Toll Restriction (BRD)
- Program #58-A is assigned "0".
- The telephone must be assigned by Program #61-D = “0” (Printed).
G: Busy (ATB)
- When busy condition in all line passed more than 1 minutes in Queuing group, start time is set. And
when more than one line comes to be idle, and it passed more than 1 minutes, finish time is set.
From start time to finish time is printed-out as busy time of the Queuing group.
H: Buffer over (BFL)
- When the Data beyond Buffer's capacity (8 house/line) while printer is busy condition (including
power off), the number of non-printed-out Data (Total in 1 hour) is printed-out.
3. SMDR Printout Format

: Space (ASCII = 20H) @: CR (ASCII = 0DH) <: LF (ASCII = 0AH)