Nitsuko 1232 - Flash; Pulse to Tone Conversion

Trunk Outgoing Call
¾ 4-8 ¾
To cancel Dial Block:
<KTS>
1. Press SPK key.
2. Press ICM key. (TX-Z 824/1232/2464 only) (See Note 1)
3. Dial
*
, # (TX-Z 824/1232/2464).
Dial 95 (TX-Z 308).
4. Dial 4-digit code which is entered when setting Dial Block.
5. Dial #.
- Confirmation tone when effective.
- Error tone when not effective.
<SLT>
1. Lift handset.
2. Dial function code. (See Note 2)
3. Dial 4-digit personal code which is entered when setting Dial Block.
4. Replace handset.
Note 1: If Program #75-D is 0 (No tone), skip Step 2. (TX-Z 824/1232/2464)
Note 2:
Program #20-D Data Automatic Trunk Access Code for SLT Dial at Step 2
Dial Plan 1 - - 66
0 0 956
Dial Plan 2
1 9 056
RELATED SYSTEM DATA:
35-C: Toll Restriction Class (Dial Block)
n
nn
n Flash
DESCRIPTION:
The flashing time can be set by system program (#26) to two different timings for CO lines and PBX lines.
To send a flashing signal, just depress the FLASH key after seizing a CO/PBX line.
STATION APPLICATION:
KTS, SLT
OPERATION:
<KTS>
1. On the CO/PBX line
2. Press FLASH key.
<SLT>
(On the CO/PBX line)
1. Flash Hookswitch.
2. Dial 90.
RELATED SYSTEM DATA:
#26: Flash Timer
n
nn
n Pulse to Tone Conversion
DESCRIPTION:
Pulse to Tone Conversion allows you to change from Pulse to Tone dialing mode to access services
such as computer-accessed long distance service.
STATION APPLICATION:
KTS