¾ 7-2-2-1 ¾
Fax/Operator Call
Description
When there is an incoming call from outside caller on Fax / DUD Line which is assigned by
Program #67, the system automatically answers and sends Greeting Message (Message
No.1) to outside caller.
<< Example Message for Message No.1 >>
Thank you for calling. This is Nitsuko Corporation. If you wish to send your Fax Message,
please press “START” key now. If you wish to talk, please wait a moment. Operator will
answer.
If “START” key is pressed by outside caller within defined time (Program #69-2) ...
(CNG Signal* is detected)
The call shall automatically be transmitted to the connected Fax Machine. The outside
caller (Fax Machine) can make communication with connected Fax Machine.
If assigned time (Program #69-2) has passed ... (CNG Signal* is not detected)
Transfer Message (Message No.4) is sent to outside caller and this call shall automatically
be transferred to the Operator (No.10 Extension).
(*) CNG Signal may be sent from outside caller (Fax Machine)
Note 1 : Only Operator’s extension (No.10) shall ring.
Note 2 : Other extension users can pickup this call by using “Call Pickup” operation or press
flashing Line Key.
Note 3 : In case the Operator is in busy status, muted ringing tone is sent from built-in
speaker and a Line key flashes green at Operator’s extension.
Note 4 : If nobody answers within assigned time (Program #69-4), Termination Message
(Message No.5) is sent to outside caller and this call shall be terminated.
Note 5 : In case the connected Fax Machine is in busy status, the call shall be terminated.
Note 6 : Some old type Fax Machine may not send CNG Signal. If Operator answers and
hears no sound, this call shall be transferred to the Fax Machine by manual
operation.
.
Related Programming
Program #68-A : Line Type (should be set to “0”)
Program #68-B : When CNG Signal is not detected (should be set to “1”)
Program #69-2 : CNG Signal Waiting Time
Program #69-4 : SLT/FAX Calling Time
To Next Page
Loading...