¾ 7-2-2-5 ¾
Hold and Transfer to Fax Machine
Description
In case an extension user answers to Fax call due to some reason (miss-operation by the
outside caller, etc...), this call can be transferred to the connected Fax Machine by manual
operation.
Related Programming
None
Operation
< Key Telephone >
1. Answer an incoming call. (CNG Signal may be heard.)
2. Press TRFR key.
Confirmation Tone (short beep tone) shall be heard if transmission is successful. If
Error Tone (200ms ON/OFF : 3 times) is heard, transmission is failed due to some
reason (Fax Machine is in busy status, etc...).
3. Hang up.
< Single Line Telephone >
1. Answer an incoming call. (CNG Signal may be heard.)
2. Hookflash.
3. Dial the extension No. of Fax Machine and hang up.
Outgoing Call from Fax Machine
Description
The Fax data can be sent from the connected Fax Machine to outside Fax Machine without
dialing a trunk access code.
Related Programming
Program #75-C : Automatic Trunk Access (should be set to “1”)
Operation
1. Go off-hook at Fax Machine. (Dial Tone from Exchange shall be heard.)
2. Dial outside Fax Number.
3. Press START key after the outside Fax Machine answers.
(Note) : This feature disables the Fax Machine to make intercom outgoing calls.
To Next Page
Loading...