Nitsuko 1232 - Camp-On (Trunk Queuing); Key Touch Tone

Trunk Outgoing Call
¾ 4-9 ¾
OPERATION:
1. Dial phone number. (Pulse mode).
2. Dial #.
3. Dial phone number. (Tone mode).
RELATED SYSTEM DATA:
#01-B: Dial Mode
n
nn
n Camp-On (Trunk Queuing)
DESCRIPTION:
When all trunk lines in a particular Queue Group are busy, Camp-On puts an extension user on a
"waiting list" for an available line in the group. As soon as a line becomes free, the user's phone rings and
a Line key flashes. Up to eight extension users can activate Camp-On in the same Queue Group. When
signaled, the user must answer within 20 sec, otherwise the line rings the next extension on the "waiting
list".
STATION APPLICATION:
KTS, SLT
OPERATION:
To use Camp-On:
<KTS>
1. Lift handset.
2. Press ICM key. (TX-Z 824/1232/2464 only) (See Note)
3. Press HOLD key.
4. Dial Queuing Group number (0-6) (0: Same group, 1- 6: Group No.).
- If you hear busy tone, the extension can not use Camp-On for that group.
5. Replace handset.
<SLT>
1. Place an outside call. Hear busy tone.
2. Dial Queuing Group number (0-6) (0: Same group, 1- 6: Group No.).
3. Replace handset.
Note : If Program #75-D is 0 (No tone), skip Step 2. (TX-Z 824/1232/2464)
When Camp-On rings an extension:
<KTS>
1. Lift handset.
2. Press flashing Line key.
<SLT>
1. Lift handset.
RELATED SYSTEM DATA:
#01-C: Queuing Group - Line Assignment
#16-B: Recall Trunk Off-Hook Access
n
nn
n Key Touch Tone
DESCRIPTION:
The Key Touch Tone feature allows a tone to be emitted from the built-in speaker each time a Line,
One-Touch or dial pad key is pressed. The tone confirms the key was fully pressed.
STATION APPLICATION:
KTS