Nitsuko 1232 - Page 361

¾ 7-3-3-9 ¾
Features on DISA
To reset Absent Mode:
Display Indication Operation and Information
##SUN# 25# 12:00PM
1. Lift handset or press SPK.
2. Press ICM key. (See Note)
3. Press TRFR twice.
##SUN# 25# 12:00PM
10##############
4. Hang up or press SPK. (TRFR key will go off.)
Note : When Program #75-D is 0 (No tone), skip Step 2.
To record an Absent Message (Personal Message):
(This operation requires that extension is set the
Absent Mode
.)
Display Indication Operation and Information
##SUN# 25# 12:00PM
REC.TRFR.MESSAGE
1. Lift handset or press SPK. (See Note 1)
2. Dial 950. (see Note 2)
00:00:00# 12:00PM
REC.TRFR.MESSAGE
3. Dial
*
. (Recording and timer counting start.)
4. Record a message from handset or MIC.
00:00:06# 12:00PM
REC.TRFR.MESSAGE
5. Dial
*
. (Recording and timer counting finish.)
(For Example: Recording time is 6 sec.)
(see Note 2)
##SUN# 25# 12:00PM
10##############
6. Hang up or press SPK.
* When user hangs up or presses SPK without dialing
*
or
#, the recorded message will be saved. When maximum
time of recording (4/8/12/16 sec.) has passed during
record message, timer counting will automatically be
finished and the recorded message will be saved.
Note 1: When Program #75-D is 0 (No tone), press ICM key
to seize Intercom after lifting handset.
Note 2: When VAU unit is not inserted in the system, Voice
Paths are occupied or Memory area for the Personal
Message is full condition, Busy Tone will be sent.
Note 3: If user dials "#" instead of "
*
", recorded contents will
be canceled and Dial Tone may be sent.