¾ 7-3-3-10 ¾
Features on DISA
To confirm an Absent Message (Personal Message):
Display Indication Operation and Information
##SUN# 25# 12:00PM
PLY.TRFR.MESSAGE
1. Lift handset or press SPK. (See Note 1)
2. Dial 951. (Playing start.) (see Note 2, 3)
3. Hear a message from handset or built-in speaker.
(see Note 4)
##SUN# 25# 12:00PM
10##############
4. Hang up or press SPK.
Note 1: When Program #75-D is 0 (No tone), press ICM key
to seize Intercom after lifting handset.
Note 2: When VAU unit is not inserted in the system or Voice
Paths are occupied, Busy Tone will be sent.
Note 3: When Personal Message is not recorded, Dial Tone
may be sent.
Note 4: When recorded contents has been finished, 1-beep
tone (400 Hz, 0.5 sec.) will be sent.
To Confirm the Left Messages
On the Leave a Message (from outside), Leave a Telephone Number, General Message and
Message Waiting features, when Messages or Telephone Numbers are left by the other extension or
outside caller, MW Lamp/Indicator at KTS is flashing. Confirming operation (Press CHECK and dial
*
) is common for Leave a Message (from outside), Leave a Telephone Number, General Message
and Message Waiting features. When the extension has been set these features at the same time,
left messages or telephone numbers will be confirmed according to the following order.
Order: Leave a Message
®
Leave a Tel. No.
®
General Message
®
Message Waiting
To confirm the existence of left Telephone Number:
Display Indication Operation and Information
##SUN# 25# 12:00PM
PLAY# MESSAGE###
1. Lift handset or press SPK. (See Note)
2. Dial
*
.
* After this operation, if there are some left Telephone
Number, VAU Message No. 15 will be sent to KTS with
Display user. When VAU Message has been finished, 1-
beep tone (400 Hz, 0.5 sec.) will be sent.
3. Hang up or press SPK.
Note 1:When Program #75-D is 0 (No tone), press ICM
key to seize Intercom after lifting handset.
To Next Page
Loading...