¾ 7-3-3-7 ¾
Features on DISA
To erase all Left Messages:
Display Indication Operation and Information
(KTS)
1. Lift handset or press SPK.
2. Press ICM key. (See Note 1)
3. Dial
*
and 0 and #. (see Note 2, 3)
4. Hang up or press SPK.
(SLT)
1. Lift handset.
2. Dial 68. (Dial Plan 1) (see Note 2)
or
2. Dial 058 (958). (Dial Plan 2) (see Note 2, 3)
3. Hang up.
Note 1: When Program #75-D is 0 (No tone), skip Step 2.
Note 2: This operation is a same canceling operation of
Message Waiting and General Message at receiving
extension, and Leave a Telephone Number features.
When this operation has been done, all the features
which had been set will be canceled, and MW
lamp/Indicator will go off.
Note 3: When messages are erased, Dial Tone may be sent.
To go off the MW lamp/Indicator:
(This operation is available at
only KTS
.)
Display Indication Operation and Information
(On Hook condition)
1. Press OPAC and CLEAR.
To leave a Message:
(Outside caller operation.)
1. Call the DISA line.
2. Hear VAU Message (No. 02).
3. Dial desired extension number.
4. Hear Personal Message. (Absent Message)
5. Hear VAU Message (No. 06 or 07).
6. Dial 1.
7. Hear VAU Message (No. 11).
8. Hear 1 beep tone.
9. Start recording.
10.Dial #. (Recording finish.) (see Note)
11.Hear VAU Message (No. 13).
12.Hang up.
Note:
When outside caller hangs up without dial #, the recorded message will be saved.
RELATED SYSTEM DATA:
#64-A: Maximum Time of Personal Message
#66: DISA Timers
To Next Page
Loading...