¾ 7-3-3-6 ¾
Features on DISA
To confirm Left Message(s): (Cont'd)
Display Indication Operation and Information
(SLT)
1. Lift handset.
2. Dial 7 and
*
. (Dial Plan 1) (see Note 1, 3, 5)
or
2. Dial
*
. (Dial Plan 2) (see Note 1, 3, 5)
Note 1: When Voice Paths are occupied, Busy Tone will be
sent.
Note 2: After this operation, user can also confirm message
from handset.
Note 3: After confirmed message, user can select the
message to be confirmed by dialing
*
or #.
(
*
: Scroll forward, #: Scroll backward)
Note 4: When Program #75-D is 0 (No tone), press ICM key
to seize Intercom after lifting handset.
Note 5: When recorded contents has been finished, 1-beep
tone (400 Hz, 0.5 sec.) will be sent.
To transfer Left Message(s):
Display Indication Operation and Information
(KTS, SLT)
1. Listen a left message.
2. Dial # and dial desired extension number.
3. Hang up or press SPK.
To erase Left Message(s) individually:
Display Indication Operation and Information
LEAVE# A # MESSAGE
TOTAL# 05######01
(KTS with Display)
1. Press CHECK and dial
*
.
(For Example: If total 5 messages are left, then first
message will be erased.)
* User can select the message to be erased by dialing
*
or
#. (
*
: Scroll forward, #: Scroll backward)
##SUN# 25# 12:00PM
2. Press HOLD.
(Message No. 1 is erased.)
(KTS, SLT)
1. Listen a left message.
2. Dial 0. (see Note)
3. Hang up or press SPK.
Note: If messages are erased, Dial Tone may be sent.
To Next Page
Loading...