¾ 7-3-3-5 ¾
Features on DISA
To confirm an Absent Message (Personal Message): (Cont'd)
Display Indication Operation and Information
(SLT)
1. Lift handset.
2. Dial 7 and 951. (Dial Plan 1) (see Note 2, 3)
or
2. Dial 0571 (9571). (Dial Plan 2) (see Note 2, 3)
3. Hear a message from handset. (see Note 4)
4. Hang up.
Note 1: When Program #75-D is 0 (No tone), press ICM key
to seize Intercom after lifting handset.
Note 2: When VAU unit is not inserted in the system or Voice
Paths are occupied, Busy Tone will be sent.
Note 3: When Personal Message is not recorded, Dial Tone
may be sent.
Note 4: When recorded contents has been finished, 1-beep
tone (400 Hz, 0.5 sec.) will be sent.
To Confirm the Messages
On the Leave a Message (from outside), Leave a Telephone Number, General Message and
Message Waiting features, when Messages or Telephone Numbers are left by the other extension or
outside caller, MW lamp/Indicator at KTS is flashing. Confirming operation (Press CHECK and dial
*
)
is common for Leave a Message (from outside), Leave a Telephone Number, General Message and
Message Waiting features. When the extension has been set these features at the same time, left
messages or telephone numbers will be confirmed according to the following order.
Order: Leave a Message
®
Leave a Tel. No.
®
General Message
®
Message Waiting
To confirm Left Message(s):
Display Indication Operation and Information
LEAVE# A # MESSAGE
TOTAL# 05######01
(KTS with Display)
1. Press CHECK and dial
*
.
(For Example: If total 5 messages are left, then first
message will be confirmed.)
* User can select the message to be erased by dialing
*
or
#. (
*
: Scroll forward, #: Scroll backward)
##SUN# 25# 12:00PM
PLAY# MESSAGE###
2. Press ICM. (see Note 1, 2, 3)
(Play-back message No. 1.)
(KTS)
1. Lift handset or press SPK. (See Note 4)
2. Dial
*
. (see Note 1, 2, 3, 5)
(Play-back message.)
To Next Page
Loading...