Intercom Outgoing Call
¾ 4-40 ¾
To call the extension that left a Message Waiting indication:
<KTS>
1. Seize Intercom.
2. Dial
*
(TX-Z 824/1232/2464).
Dial 87 (TX-Z 308). The extension is called.
3. To call the next extension that left a Message Waiting indication, dial
*
again.
<SLT on Dial Plan 1>
1. Lift handset. (Hear Message Waiting dial tone)
2. Dial 7, wait dial tone. (see Note 2)
3. Dial
*
.
<SLT on Dial Plan 2>
1. Lift handset. (Hear Message Waiting dial tone)
2. Dial
*
.
To cancel all Message Waiting indications:
<KTS>
1. Lift handset.
2. Press ICM key. (TX-Z 824/1232/2464 only) (See Note 1)
3. Dial
*
, 0,
*
(TX-Z 824/1232/2464).
Dial 94, 0,
*
(TX-Z 308).
4. Hang up.
<SLT>
1. Lift handset.
2. Dial function code. (see Note 3)
Note 1 :If Program #75-D is 0 (No tone), skip Step 2 (TX-Z 824/1232/2464).
Note 2: When SLT is set this feature, the SLT's dial tone changes from continual tone to 0.4 sec. On/0.1 sec. OFF.
Note 3:
Program #20-D Data Automatic Trunk Access Code for SLT Dial at Step 2
Dial Plan 1 - - 69
0 0 959
Dial Plan 2
1 9 059
To cancel an individual Message Waiting:
<KTS only>
1. Lift handset.
2. Press ICM key. (TX-Z 824/1232/2464 only) (See Note 1)
3. Dial
*
, destination extension number,
*
(TX-Z 824/1232/2464).
Dial 94, destination extension number,
*
(TX-Z 308).
4. Hang up.
<KTS with LCD only>
- Do not lift handset -
1. Press OPAC key
2. Press CLEAR key. (see Note 2)
Note 1 :If Program #75-D is 0 (No tone), skip Step 2 (TX-Z 824/1232/2464).
Note 2: This operation can be available at extension which MW is set. The extension has to be only KTS with LCD.
To Next Page
Loading...