• 6-32 •
3URJUDP#4;/#4</#53/#97
SYSTEM ASSIGNMENT 0 1 2 3
Common abbreviated dial
restriction (0 or 1)
0 = Disable
1 = Enable
( ) ( )
Handset receiver volume
(0 or 1)
0 = Reset after conversation
1 = Keep current volume
( ) ( )
Time indication
(0 or 1)
0 = 12H mode
1 = 24H mode
( ) ( )
All call to external zone
(0-3)
0 = Disable
1 = Speaker 1
2 = Speaker 2
3 = Speaker 1 and 2
( )( )( )( )
Intercom signaling
(0 or 1)
0 = Voice call
1 = Signal call
( ) ( )
Microphone ON/OFF
(0 or 1)
0 = ON
1 = OFF
( ) ( )
Room monitor
(0 or 1)
0 = Disable
1 = Enable
( ) ( )
SLT hold transfer
(0 or 1)
0 = Cutoff
1 = Transfer to Operator (No.10)
( ) ( )
Door chime tone duration
(0 or 1)
0 = 5 seconds
1 = 30 seconds
( ) ( )
Paging splash tone
(0 or 1)
0 = Disable
1 = Enable
( ) ( )
Splash tone on doorphone
(0 or 1)
0 = Disable
1 = Enable
( ) ( )
Automatic trunk access
code for SLT (0 or 1)
0 = Off-Hook and dial 0
1 = Off-Hook and dial 9
( ) ( )
Doorphone box (0-3) 0 = None
1 = Doorphone 1 enabled
2 = Doorphone 2 enabled
3 = Doorphone 1and 2 enabled
( )( )( )( )
Maximum time of Personal
Message (0 - 3)
0 = 4 sec.
1 = 8 sec.
2 = 12 sec.
3 = 16 sec.
( )( )( )( )
Temporary Memory Status
For Caller-ID (0 or 1)
0 = Not Indicate
1 = Indicate
( ) ( )
Automatic Trunk seizing
Type selection (0 - 2)
0 = Seize from small number
1 = Seize from large number
2 = Seizing rotating line
( ) ( ) ( )
LED indication for DISA
incoming call (0 or 1)
0 = Busy (not to answer)
1 = Normal incoming (O.K. to answer)
( ) ( )
SLT hold Operation
(0 or 1)
0 = Enable
1 = Disable
( ) ( )
To Next Page
Loading...