¾ 7-3-3-17 ¾
Features on Transfer
To record a Transfer Message (Personal Message):
(This operation requires that extension is set the
Call Forward Mode
.)
Display Indication Operation and Information
##SUN# 25# 12:00PM
REC.TRFR.MESSAGE
(KTS)
1. Lift handset or press SPK. (See Note 1)
2. Dial 950. (see Note 2)
00:00:00# 12:00PM
REC.TRFR.MESSAGE
3. Dial
*
. (Recording and timer counting start.)
4. Record a message from handset or MIC.
00:00:06# 12:00PM
REC.TRFR.MESSAGE
5. Dial
*
. (Recording and timer counting finish.)
(For Example: Recording time is 6 sec.)
(see Note 3)
##SUN# 25# 12:00PM
10##############
6. Hang up or press SPK.
* When user hangs up or presses SPK without dialing
*
or
#, the recorded message will be saved. When maximum
time of recording (4/8/12/16 sec.) has passed during
message recording, timer counting will automatically be
finished and the recorded message will be saved.
(SLT)
1. Lift handset.
2. Dial 7 and 950. (Dial Plan 1) (see Note 2)
or
2. Dial 0570 (9570). (Dial Plan 2) (see Note 2)
3. Dial
*
. (Recording start.)
4. Record a message from handset.
5. Dial
*
. (Recording is finished and Dial Tone may be sent.)
(see Note 3)
6. Hang up.
* When user hangs up without dialing
*
or #, the recorded
message will be saved. When maximum time of recording
(4/8/12/16 sec.) has passed during message recording,
timer counting automatically be finished and the recorded
message will be saved.
Note 1: When Program #75-D is 0 (No tone), press ICM key
to seize Intercom after lifting handset.
Note 2: When VAU unit is not insert in the system, Voice
Paths are occupied or Memory area for the Personal
Message is full condition, Busy Tone will be sent.
Note 3: If user dials "#" instead of "
*
", recording contents will
be canceled and Dial Tone may be sent.
To Next Page
Loading...