NSK Megatorque PS Series User Manual

— 9-8 —
Ì P AG : (Factory use only)
 The command is for factory use only. Do not change the setting.
AM: Alarm
 This is to monitor current alarm or warning.
Category Monitor
Format
AM
 This function monitors currently reported abnormality in the System.
◊ Once an abnormal state is detected in the System, the Driver Unit gets in alarm or
warning state and holds this situation until it is cleared. The command TA (Tell alarm)
monitors the detected alarm and warning.
◊ The monitor AM is to monitor only currently occurring abnormality, not the
abnormality held by the Driver Unit.
◊ The following show a monitoring example and corresponding alarm and warning.
◊ Input AM or AM/RP.
Press the BS
key to abort repetitive monitoring.
Fig 9-1: Example of Monitor AM
TA/RP
FEDCBA9876543210
0000000000000000
0000000000000000
State of alarm
Guide
0: Normal
1: Alarm
Table 9-2:Readout of Monitor AM
Guide F E D C B A 9 8 7 6 5 4 3 2 1 0
F3 (-) F3 (+) F2 (-) F2 (+)
F8 F5 P5 C5 C0 A4 A3 F1 P9 P3 P2 P1
Alarm code
P0 A9 A7 A2 A1 A0 C4 C3 A5 F4 E9 E8 E7 E2 E0

NSK Megatorque PS Series Specifications

General

Brand	NSK
Model	Megatorque PS Series
Category	Engine
Language	English