NSK Megatorque PS Series - Page 252

— 9-28 —
FTJO: Function TJO
 This is to monitor the state of the output JO (Thermal loading, under).
◊ Refer to “7.3.1.5. Monitor for Individual Function” for details.
 For the monitored state, the parameters ST (Stability timer) and GC (Output logic) in the
command PO (Edit output port) are not applied.
Category Monitor
Format
FTJO
0
: Not detected
Data range
1
: Thermal loading is less or equal to the threshold.
FTJU: Function TJU
 This is to monitor the state of the output TJU (Tell thermal, under).
◊ Refer to “7.3.1.5. Monitor for Individual Function” for details.
 For the monitored state, the parameters ST (Stability timer) and GC (Output logic) in the
command PO (Edit output port) are not applied.
Category Monitor
Format
FTJU
0
: Not detected
Data range
1
: Thermal loading is less or equal to the threshold.
FTTO: Function TTO
 This is to monitor the state of the output TTO (Tell torque command, over).
◊ Refer to “7.3.1.5. Monitor for Individual Function” for details.
 For the monitored state, the parameters ST (Stability timer) and GC (Output logic) in the
command PO (Edit output port) are not applied.
Category Monitor
Format
FTTO
0
: Not detected
Data range
1
: Torque command is greater or equals to the threshold.