NSK Megatorque PS Series User Manual

— 9-65 —
TG: Tell Gain Switching
 This monitor reports the state of the automatic gain switching function.
◊ Refer to “8.5.4. Automatic Gain Switching” for details.
Category Monitor
Format
TG
Data range
0
1
: The gains for gain switching are applied. (Parameters PGL and VGL)
: The normal gains are applied. (Gains PG and VG)
Pex. TI: Timer
 This parameter sets the pausing time of an operation to a program.
◊ Refer to “6.3.2.4. Program Sequence” for details.
Category Parameter
Format
TI data
Data range 0.0 to 10 000.0 [ms]
 At the state of the normal command prompt, an input of the command “?TI” reports the residual
time of the timer currently applied.
TJ: Tell thermal
 This monitor reports the thermal loading.
◊ Refer to “7.3.6. Software Thermal Loading Monitor: Monitor TJ” for details.
◊ The warning A3 (Over Load) occurs when the readout of the monitor TJ is 100.
 It is essential to reduce the thermal loading to 0% for continual operation of one “user defined”
cycle.
Category Monitor
Format
TJ
Data range 0.00 to 100.00%
P TJO: Tell thermal, over
 This parameter specifies the threshold of the thermal loading to activate the output TJO
(Thermal loading over).
◊ Refer to “8.3.2.4. Thermal Loading: Outputs TJU (Thermal Loading, Under) and TJO
(Thermal Loading, Over)” for details.
◊ The output TJO reports that the thermal loading is over when it is greater or equal to
the setting of the parameter TJO.
Category Parameter
Format
TJO data
Data range 0.00 to 100.00%
Shipping set 0.00

NSK Megatorque PS Series Specifications

General

Brand	NSK
Model	Megatorque PS Series
Category	Engine
Language	English