4
Additional copy operations
4-12 CS193/CS173/CS163
?
Can the copy program name be corrected?
% To change the entered copy program name, touch the button whose name is to be changed, and
then touch [Edit Name]. The Edit Name screen appears. Return to step 4 and repeat the procedure
to change the copy program name.
?
Can the specified settings for a copy program be checked?
% To check the programmed copy settings, touch the button for the desired copy program, and then
touch [Check Program Settings]. For details, refer to "Copying with programmed copy settings
(Mode Memory)" on page 4-14.
6 Touch [OK] or [Cancel].
– To return to the Basic screen, press the [Mode Memory] key.
!
Detail
To stop registering the program, press the [Reset] key or the [Mode Memory] key.
No matter which screen is displayed, the registration is cancelled.
Otherwise, continue to touch [Cancel] until the Basic screen is displayed.
The settings of a copy program cannot be changed.
If the copy program that was selected has been locked, [Edit Name] and [Delete] do not appear. For
details, refer to "System Settings" on page 12-23.
To Next Page
Loading...
