Oce CS193 - Punch Regist Loop Size Adjustment

12
Utility mode
12-50 CS193/CS173/CS163
6 Touch the button for the paper type to be adjusted.
Check the horizontal position of the punched holes.
– To increase width A, touch [+] to increase the adjustment (between 1 and 10).
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
– To decrease width A, touch [-] to decrease the adjustment (between -1 and -10).
7 Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completes
the procedure.
8 Use a Punch setting to print another sample copy.
9 Check the print result.
– Check that the horizontal position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
12.8.4 Punch Regist Loop Size Adjustment
When printing with a Punch setting, the angle of punched holes along the side of the paper can be adjusted.
2
Note
[Punch Regist Loop Size Adjustment] does not appear if optional finisher and punch kit are not installed.
!
Detail
For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 3-75.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.